Boxfish ROV Owner’s Manual
p73
V1.3 All rights reserved. Information and specifications may change at any time without notice.
Refit thruster mounting plate
a.
Align thruster mounting plate pin with the cowl mounting screw and
secure with 4 x hex head screws
Thruster mounting plate attached to cowl
How to fit a thruster to the ROV
Ensure ROV is powered off and vacuum removed
Fit thruster to the ROV:
a.
Move thruster into position with threaded holes on the mounting plate
aligned to the holes on the thruster mounting point on the ROV
b.
Ensure thruster cable is not trapped and is in the correct orientation to
allow it to be plugged into the thruster port
c.
Slide the 2 x hex head screws through the ROV mounting point into
the thruster mount. Tighten with an Allen key.
Thruster mounting point
Plug in thruster cable
a.
Align the three holes on the thruster cable plug with the three pins in
the thruster port. Note: the plug is not keyed, ie the orientation of the
three pins does not affect operation