Boxfish ROV Owner’s Manual
V1.3. All rights reserved. Information and specifications may change at any time without notice.
p78
d.
When the tray is inserted far enough for the bolts to almost engage
the threads, stop and check o-ring seals are correctly positioned.
e.
Ensure alignment pins in the ROV tray are aligned with the holes in the
ROV body, and push the ROV forward until you feel resistance from
the o-ring seals.
Screw in bolts
a.
Use your fingers to tighten bolts into the threaded holes on the ROV
body. Alternate the bolts so they are evenly tightened.
b.
Once bolts are finger tight use the Allen Key to tighten bolts a small
amount at a time using the pattern Top Right, Bottom Left, Top Left,
Bottom Right until the tray is firmly sealed and the bolts are tight.
Power on ROV and check operation.
Check ROV can hold a vacuum.