Boxfish ROV Owner’s Manual
p87
V1.3 All rights reserved. Information and specifications may change at any time without notice.
3-5: Currently no function
6: Restart telemetry application – restarts telemetry screen while
allowing 4K screen and pilot controls to remain functional.
19. Contextual buttons (row on right side of telemetry screen):
7: Currently no function
8: Grabber open control: Pressing down and
holding this button will open the grabber accessory
(if grabber is present)
9: Grabber close control: Pressing down and
holding this button will close the grabber (if
grabber is present)
10: Currently no function.
11: Currently no function.
12: Disable Water Sensor:
Do not use unless
directed by Boxfish
. Press and hold this button for
six seconds disables the water sensor. This will
allow the thrusters to be enabled and the lights to
run at 100% even if ROV is out of the water. Press
and hold again for six seconds to re-enable water
sensor.
IMPORTANT NOTE
: lights should not be
run at above 5% for more than 20 seconds unless
they are underwater.
13. Calibrate Compass: if you need to re-calibrate
the compass, see
Appendix V: Troubleshooting
.
20. Scaling lasers On/Off switch: If the optional scaling lasers are fitted this
switch will turn the scaling lasers on and off.
1.
ON - Turn on the scaling lasers. DO NOT look directly into the ROV
scaling lasers. The scaling lasers emit Class 3R laser light.
2.
OFF - Turn off the scaling lasers.
