apparatus, the apparatus has been exposed to rain or moisture, does not operate normally,
or has been dropped.
12) This appliance should not be exposed to dripping or splashing water and no such as
vases, should be placed on the apparatus.
13) Do not overload the wall power outlet. Use only power source as indicated -
i.e.100V AC mains.
Avoid installing this unit in places exposed to direct sunlight or close to on top of other
stereo equipment that radiates too much heat, places lacking constant vibration and/or
humid or moist areas.Do not attempt to clean this unit with chemical solvents as this might
damage the finish.Use a clean dry cloth.Operate controls and switches as described in make
certain the AC power cord is plugged in.Store your CDs, Cassettes in a cool area to avoid
damage from heat. When moving the set,be sure to first disconnect the power cord.
UNPACKING AND SET UP
1) Carefully remove the unit from the display carton and remove all packing
2 ) Unwind the AC power cord and extend it to its full length.
3) Unwind the FM Antenna wire and extend it to its full length.
4) Place the unit on a stable, level surface, convenient to an AC outlet, out of Direct sunlight,
and away from sources of excess heat, dust, moisture, humidity or strong magnetic fields.
5)Remove the opaque white plastic stylus cover from the phonograph stylus by sliding it
forward and down.
6)Discard the stylus cover．Remove the twist-tie that was used to secure the tone arm during
shipment.
7) Release the tone arm lock lever.
8)Connect the plug to your AC outlet.
POWER SOURCE
