4
ID Recall
Device mode (3 seconds)
PREV
(RECALL)
If you used the Power Scan to find a code,
the ID Recall function will show you the
code for any programmed device.
1.
On the remote control, press and hold the
applicable device mode button ([TV] [VCR]
[DVD] [CBL/SAT]) until the indicator light in
the upper left-hand corner begins to blink
(approximately 3 seconds).
2.
As soon as the indicator light begins to blink,
release the device mode button.
3.
On the remote control, press and release the
PREV (RECALL) button.
4. As soon as you release the PREV (RECALL)
button, the indicator light in the upper left-hand
corner will show you the code for your device by
blinking the 100’s, 10’s and 1’s of
your code.
5. Count the number of blinks to determine the
code. A ‘0’ in any location is represented by a
Example: Code 102 is shown as BLINK <pause> FLICKER
<pause> BLINK, BLINK.
Volume Punch Through
Master Power
Device mode (3 seconds)
ON/OFF
ON/OFF
The Master Power function allows you to
turn the power on or off for all programmed
devices at the same time.
1. Program the remote control to all of your
devices.
2. Power on all of your devices.
Menu Device mode
The Menu Device mode allows you to
use the blue arrow buttons (
) to
navigate a programmed device.
1. Make sure that the device you want to use has
been programmed into the remote control.
2. Press and release the MENU button.
3. In Menu De
vice mode, use arrow buttons (
) to navigate.
4.
Once the desired menu item is reached, press
and release the ENTER (SELECT) button to
select it.
NOTE: If an
y button other than
or ENTER
(SELECT) is pr
essed or if no buttons a
re pressed within 20
seconds, the remote control will exit Menu Device mode.
Device mode (3 seconds)
Device mode
(hold)
TV
The Volume Punch Through function allows
you to change the volume on your TV while
in CBL/SA
T, DVD or VCR mode.
1. Program the remote control to your TV and other
media devices.
2.
On the remote control, press and hold the
applicable device mode button ([CBL/SAT], [VCR],
[DVD]) until the indicator light in the upper left-
hand corner begins to blink (approximately 3
seconds).
3.
As soon as the indicator light begins to blink,
release the Device mode button.
4.
On the remote control, press and hold the same
device mode button again and then also press and
hold the [TV ] button at the same time.
3.
On the remote control, press and hold the d
evice
mode button ([TV] [VCR] [DVD] [CBL/SAT]) until
the indicator light in the upper left-hand corner
begins to blink (approximately 3 seconds).
(Use [CBL/SAT] at Step 3 if you have cable or
satellite devices.)
4.
As soon as the indicator light begins to blink,
release the device mode button.
5.
On the remote control, press and release the
PWR button.
6.
Again, on the remote control, press and release
the PWR button.
7. To disable Master Power
,
repeat the steps above.
5.
release both buttons.
