BRADEN CH330, Installation Maintenance And Service Manual

13

WEIGHTS, OIL CAPACITIES, 

AND SPECIAL TOOLS

SPECIAL TOOLS

  2 each 5/16-18NC eyebolt

  2 each 1/2-13NC eyebolt

  2 each 3/4-10NC eyebolt:

NOTE:

 The first two items below are required only if the 

motor support is separated from the ring gear.  

The other tools are required to service the brake 

assembly.

a) 1-inch diameter bar approximately 36 inches 

long and various sized small steel blocks (key 

stock).

b) 3 each 7/8-9NC x 6-inch long capscrews

c) A ratcheting internal snap ring pliers capable of 

handling an N5000 700 snap ring.

All units use a single coil spring to apply the inter-

nal brake.  The following spring compressor must 

be fabricated and is strongly recommended.

NOTE:

 If a press is available (with at least 5 inches of trav-

el), only part A (shown at right) is required (center 

hole not required). If a press is not available, all 

parts shown and listed below are required.

a) 1 each 3/4-16NF threaded rod, 4 inches long

b) 1 each 3/4-16NF nuts

c) 1 each 3/4-inch plain washer

  Ferry capscrew sockets 3/4-inch drive 12 point

  5/8-inch 

Proto P/N – J07510T

Snap-On P/N – IMD202A

  3/4-inch 

Proto P/N J07512T

Snap-On P/N IMD242A 

APPROXIMATE

APPROXIMATE

DRUM

WEIGHT (LBS/KG)

OIL CAPACITY (QTS/L)

01

2700/1225

40/38

02

3370/1530

65/61.5

21

3800/1725

90/85

PREVAILING AMBIENT TEMPERATURE

o

F -40     -30     -20     -10       0       10      20      30      40      50      60      70      80      90     100     110     120     130 

o

F

o

C -40             -30             -20             -10                0                10               20           30              40               50        

o

C

SHADED TEMPERATURE RANGE IN THE CHART ABOVE NOT RECOMMENDED FOR SEVERE APPLICATIONS SUCH AS SUSTAINED

            FAST DUTY CYCLES OR FREQUENT WINCHING.

Texaco

Shell

Meropa 220

Meropa 150

Omala S2 G 220

Omala S2 G 150

Chevron

Gear Compounds EP 220

Gear Compounds EP 150

PREVAILING AMBIENT TEMPERATURE

o

F -40     -30     -20     -10       0       10      20      30      40      50      60      70      80      90     100     110     120     130 

o

F

o

C -40             -30             -20             -10                0                10               20           30              40               50        

o

C

SHADED TEMPERATURE RANGE IN THE CHART ABOVE NOT RECOMMENDED FOR SEVERE APPLICATIONS SUCH AS

Mobil

Mobilgear 600 XP 220

Mobilgear 600 XP 150

Winches are factory filled with Mobilgear 600 XP 150 or equivalent. Consult your oil supplier for other equivalent

oils if required.

RECOMMENDED GEAR OIL

Omala S4 GX 150

Mobilgear SHC 150

Use gear oil detailed in Range A 

Range A

Range B

Range C

Use gear oil detailed in Range B

Use gear oil detailed in Range C