Setting Up the Cabling Infrastructure
6.
In the
Cross Connect Hardware Type
frame, enter the following: PIN Config, Cat.
Rating, Term Type, Manufacturer, and Part #.
7.
Select a
Color Code ID
from the drop-down list. This information is optional, and is
used to describe the type of hardware that can be cross-connected.
Defining Termination Hardware
NetDoc
comes with many Termination Hardware types already defined for you. If, however, you
wish to track a type of Termination Hardware that has not been defined, you can define it
yourself.
1.
To set up Termination Hardware types for your infrastructure, select the yellow button to
the right of the Termination Hardware type field in the Detail pane.
2.
Click the
Add
button.
3.
Enter the
Device Type
.
4.
The Descriptions columns allow you to assign descriptions you want to include for each
kind of Termination Hardware.
5.
Click
Save
to save your input.
6.
To delete any Termination Hardware type, click on the type, click the
Delete
button, and
then click
Save
before exiting the window.
Start and End Port/Position
Start and End Port/Position lists the number of physical connections that exist in a specific piece
of termination hardware. For Patch Panels, ports are designated; for Wiring Blocks,
positions. These physical connections must be in place for you to connect anything to the
termination hardware.
Enter the Start Port/Position number and End Port/Position number. The grayed field, Number of
Port/Positions, will be populated automatically.
For example
, if you enter "1" for Start and "50"
for End, Number of Port/Positions will be 50.
Note:
ID, Termination Type, and the Start and End Port/Positions are the only required fields to
set up Termination Hardware.
Editing Port/Position Status
The
Port/Position Details
tab shows the availability status of each Port or Position on the
termination hardware. When a Port/ Position is connected to a backbone cable, for example, its
status changes from “Available” to “Used.” The Cable Type column is populated with
“Backbone,” the Cable ID column is populated with the cable ID designation. Backbone
Pairs/Strands column shows the numbers of pairs or strands used. If a Port or Position becomes
damaged, you can edit it directly.
65
Summary of Contents for NetDoc
Page 1: ......
