In-fill Panel Kit Installation
In-fill Panel Kit Installation
9
IN-FILL PANEL KIT (P/No 085135)
z
The in-fill panel kit is used to cover the existing wall opening of wall markings when replacing
some older and taller heaters.
z
Fit the in-fill panel after the heater is fitted onto the mounting brackets as shown below.
z
Attach the in-fill panel to the wall using
screws to suit the wall type - screws to suit
plaster board, timber or masonry walls are
supplied in the in-fill panel kit).
z
Fit the screws through the snap-cap
base. Clip the snap-cap cover to the base
after fitting the screws to cover the screw
heads.
Top of heater - front
cover removed
In-fill panel
Wall opening
outline
10
