Flue Extension Kit Installation
Flue Extension Kit Installation
8
FLUE EXTENSION KIT (P/No 079943)
z
The twin-skin flue extension is used in conjunction with the flue adaptor to connect between
the flue spigot on the top of the Braemar WF2000 and the bottom of the existing flue system
to allow the WF2000 to be installed at the correct height for some replacement installations,
and to enable the use of the existing flue system (note that if the existing flue system is to be
used it must comply with the current requirements of AS5601 "Gas installations").
z
Remove and discard the liner from the flue adaptor.
z
Fit the flue adaptor onto the flue extension.
z
Fit the flue adaptor and flue extension into the bottom of the existing flue before fitting the
Braemar top mounting bracket. The location of the top and bottom mounting brackets must
comply with details given on page 4 or 5 of this manual. Trim the flue extension to length if
required.
Braemar top
mounting bracket
system and existing heater
Bottom of existing flue
top mounting bracket
extension and screw together
Discard liner, fit over flue
Flue adaptor (P/No 079981)
Trim to length to give required
Flue extension (P/No 079943)
distance between top and
bottom mounting brackets.
Must be fitted over spigot on
Braemar top mounting bracket.
