V4.0119
•
Content Subject to Change
20
M
ANUAL
M
ODE
O
PERATION
Before turning on the robotic scrubber, make sure it is fully charged and free of damage.
Perform the following steps to manually operate the machine:
1. Disconnect the AC power supply from the outlet
and then from the external battery charger.
2. Disconnect the DC cord from the machine’s
battery charger receptacle.
3. Fill the solution bottle with an approved cleaning
solution.
4. Fill the clean water tank with clean water via the
hose fi ll clean water port on the left side of the
machine or via the bucket-fi ll port located under
the recovery tank. If using the bucket-fi ll port,
make sure the recovery tank is empty before
accessing.
5. Sit in the operator seat, insert the ignition key
and turn to the right (clockwise) to turn on the
machine. Wait for the UI touchscreen to initialize.
6. Enter the 4-digit PIN via the UI touchscreen.
Upon successful PIN entry, the UI touchscreen
displays the Main Menu.
7. Press the One-Touch button to engage the
cleaning components.
8. Select the desired cleaning settings using the
solution fl ow, water fl ow, and brush pressure
controls.
9. Press the up arrow of the directional switch to
drive forward.
NOTE:
THE MACHINE CAN ONLY SCRUB WHEN
DRIVING FORWARD.
10. Press the accelerator pedal to begin scrubbing.
Speed is adjusted via the force applied to the
pedal - light is slow, heavy is fast.
NOTE:
COMPLETE REMOVAL OF PRESSURE
FROM THE ACCELERATOR PEDAL STOPS THE
MACHINE. PRESS THE BRAKE PEDAL IF FAST
STOPPING IS NEEDED OR IF OPERATING ON AN
INCLINE OR DECLINE.
11. When fi nished scrubbing, remove pressure from
the accelerator pedal and press the One-Touch
button to disengage the cleaning components.
The cleaning components will turn off after a
brief delay.
O
PERATION
