Step 9
Install the remote control holder: loosen the 3 pre-attached
screws on the outside of the right armrest with a cross-tip
screwdriver, position the holder and mount it with the
same 3 screws. Put the remote control in the bracket.
Step 10
Pick up the backrest overlay. The side on which you can
see two small cables is the top end. Connect these 2
cables with the same-coloured cables on the back frame
of the massage chair and please make sure that the trans-
parent plastic spouts fully cover the joints.
Step 11
Place the neck cushion over the backrest overlay.
Step 12
Connect the power cable with the main switch box on the
chair and plug it into a wall socket. Check again to ensure
all steps are complete – your chair is now ready for use.
Setup Instructions
Step 9
Mount the remote control holder with the
3 pre-attached screws.
10
