Page 20
Maximum Output
Brake Commander’s output can be adjusted so it does not overload hydraulic components.
To set the maximum output, enter the Settings menu (by pressing the Setup button) and
locate the Maximum Output parameter. Use the “ + ” (plus) or “ - “ (minus) button to adjust
the value. Refer to the table below for indicative 3/4” and 7/8” master cylinder outputs.
Allowable range is from 20% to 100%. The default value is 80%.
Maximum Output %
3/4” Master Cylinder - PSI
7/8” Master Cylinder - PSI
100%
1400psi
1050psi
90%
1260psi
945psi
80%
1120psi
840psi
70%
980psi
735psi
60%
840psi
630psi
50%
700psi
525psi
40%
560psi
420psi
30%
420psi
315psi
20%
280psi
210psi
NOTE
All values are indicative only and will vary due to manufacturing tolerances and
environmental conditions.
Start Point
The start point refers to the position in which Brake Commanders piston returns to when the
brakes are released. The start point can be adjusted using the “ + ” (plus) or “ - “ (minus)
button. The Brake Commander piston will jog in the desired direction accordingly. Use this
function to set the start point so as Brake Commanders piston is close (within 1mm) of the
Master Cylinders piston but not touching it. It is advisable to set this value prior to fixing the
Master Cylinder to the Brake Commander. When bringing the Master Cylinder to mounting
position by hand, no preload should be felt.
Allowable range is from 0.0mm to 45.0mm. The default value is 6.0mm. The default value
suits typical Master Cylinders used.
Serial Numbers
Serial Numbers and model designators for both the Brake Commander and the Wireless
Remote are displayed as shown below.
Device 1.1.1
000000000000
Remote 1.1.1
000000000000
Brake Commander model designator
Brake Commander serial number
Wireless Remote model designator
Wireless Remote serial number
Summary of Contents for R2-04-0
