INSTALLATION INSTRUCTIONS
8722 Instructions 2-9-15.doc
Page 2 of 6
Step 1:
Place Camera Mount in desired position to
confirm fitment. (
IMPORTANT
: Some states
prohibit items blocking the vehicle license plate;
check local authorities to confirm legal status for
your specific application).
Note: the rear trim of several GM vehicles such as
the Chevy Equinox and Cadillac CTS have slight
depressions (indicated by the arrow below) where
factory installed rear view cameras are mounted.
These positions are ideal camera locations.
Step 2:
Peel adhesive backing from supplied
Camera Mount Template and apply to the desired
location making sure that the camera direction is
correct.
Step 3:
Use a Center Punch to mark the centers of
the required three holes and drill three pilot holes
using a 1/8” drill bit. NOTE:
If your vehicle has a
liftgate panel/trunk trim cover, it must be removed.
Step 4:
Drill two 5/16” holes for the camera
mounting bolts and one 7/8” hole for the camera
harness
.
Use a Deburring Tool or Round File to
smooth edges.
Step 5
(if necessary):
Using a 7/8” drill bit, drill an
opening in the trunk or liftgate for the head of the
Camera Harness to pass through.
Insert Camera
Harness head through the backside of the hole so
that the gray connector end of the Camera Harness
is inside the trunk or liftgate. (
RECOMMENDED:
Protect Camera Harness with a rubber grommet or
by applying a small amount of silicone caulk to the
area that comes into contact with the edges of the
hole. Additional recommendation: If drilling
through sheet metal, apply a Corrosion Inhibitor.)
Step 6:
Mount the Camera using the supplied
hardware. Insert the two Rubber Well Nuts into the
outer 5/16” camera mount holes.
Step 7:
Thread the two supplied bolts through the
Camera Mount and into the Well Nuts using a
Phillips Screwdriver but do not tighten the Bolts all
the way down just yet.
Step 8:
Determine location of vehicle power and
reverse from the chart on Page 6.
NOTE:
If self-adhesive Template is missing or
damaged, cut out the image above and affix
with Masking Tape.
