12
English
Alternative B:
Keep the desired button of the original transmitter pressed and
then press the button to which you want to copy the signal. The status led flashes
briefly. Please press and hold the button until the LED of the garage door opener
flashes twice. This means that the duplication was successful.
Repeat the above step for the other buttons. The device is now ready to be used.
The status LED flashes once a signal is emitted when the button is pressed.
If the process was unsuccessful, repeat the steps again. It is advisable to clear the
memory of the remote control again.
7. Recovering the last deleted code
If you accidentally delete the code, you can restore it again by pressing and
holding the two buttons "C" and "D" simultaneously on the remote control. After
10 seconds, the LED flashes twice and goes off. This indicates that the old code
has been restored.
Note: For remote controls with fixed code and programming code, the duplicator
works after duplication.
8. Replacing the battery
Unscrew the back of the device using a suitable screwdriver. Remove the empty
battery and replace it with a 12V A27 battery.
Always pay attention to the
correct polarity of the battery.
