C
onnecting your hood
9
NOTE: "LE PLUS", for an attractive installation
BRANDT
cares about the appearance of your kitchen. You can now adjust the
hood to the tiles or credence. There is an adjustment margin of 10 mm in rela-
tion to the wall
“ AN EXCLUSIVE BRANDT FEATURE “.
Before mounting your hood on the wall:
- Remove the metal filter.
- Remove the two screws (
item 1
).
- Slightly unscrew the four screws, but do not remove
them (
item 2
).
- Pull the lower section outwards.
- Assemble and mount the hood as described .
- Adjust the lower section to be in contact with the tiles or
credence.
- Tighten the four screws (
item 2
).
- Install the metal filter.
Your hood is supplied with a power cable H05VVF, with three wires, section 0.75mm² (neu-
tral + phase and earth). Your hood should be connected to a 230 V single phase mains
power supply, through a standard power socket CEI 83, which should remain accessible
following the installation of the finishing panels, or through an omni-polar cutout, with a
contact opening gap of at least 3 mm. If the power cable is damaged, contact an authori-
sed Brandt service agent.
Your installation should include a fuse, rating 10 A or 16 A.
Détail d
tail décalage d
calage décor / mur
cor / mur
10 mm
GB
99625941_ML_A.qxd 18/11/02 13:48 Page 9
Summary of Contents for AD289XT1
