27
EN
3. INSTALLING YOUR NEW APPLIANCE
It may not work properly if being left at a
temperature above or below the indicated
range for a long period.
Climate class Ambient temperature
SN
+10°C to +32°C
N
+16°C to +32°C
ST
+16°C to +38°C
T
+16°C to +43°C
• Stand your appliance in a dry place to
avoid high moisture.
• Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away
from heat sources such as stoves, fi res or
heaters.
Leveling of appliance
• For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need
to be adjusted. You can adjust them
manually by hand or by using a suitable
spanner.
• To allow the
doors to self-
close, tilt the
top backwards
by about
10mm.
Installing the door handles
For the convenience of transportation, the
door handles are separately provided in a
plastic bag, you can install the door handles
as follows.
1. Lever screw covers on the left side of the
door, and then put them back to the plastic
bag.
2. Match the handle on the left side of the
door, keeping axes of screw holes in the
handle and the door in a line, as the picture
shows.
3. Fix the handle with the special screws
provided in the plastic bag. And then install
the handle covers.
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied) to
the left side, if the installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed from
the mains socket.
Tools you will need:
Note: Before you start lay the refrigerator on
its back in order to gain access to the base,
you should rest it on soft foam packaging
or similar material to avoid damaging the
backboard of the refrigerator. To reverse
the door, the following steps are generally
recommended.
1. Stand the refrigerator upright. Open the
upper door to take out all door racks (to
avoid racks damaged) and then close the
door.
8mm socket wrench
Thin-blade screwdriver
Cross-shaped screwdriver
8mm wrench
