27
The motor runs
continuously
lt is normal to frequently hear the sound of the
motor, it will need to run more when in following
circumstances:
•Temperature setting is set colder than necessary
•Large quantity of warm food has recently been
stored within the appliance.
•The temperature outside the appliance is too high.
•Doors are kept open too long or too often.
•After you have installed the appliance or it has
been switched off for a long time.
A layer of frost
occurs in the
compartment
Check that the air outlets are not blocked by food
and ensure food is placed within the appliance to
allow sufficient ventilation. Ensure that door is fully
dosed. To remove the frost, please refer to cleaning
and care chapter.
Temperature inside
is too warm
You may have left the doors open too long or too
frequently; or the doors are kept open by some
obstacle; or the appliance is located with insufficient
clearance at the sides, back and top
Temperature inside
is too cold
Increase the temperature by following the "Display
controls" chapter.
Doors cannot be
easily closed
easily
Check that the air outlets are not blocked by food
and ensure food is place within the appliance to
allow sufficient ventilation.
Ensure that the door is fully closed.
Water drips on the
floor
The water pan (located at the rear bottom of the
cabinet) may not be properly leveled, or the draining
spout (located underneath the top of the
compressor depot) may not be properly positioned
to direct water into this pan, or the water spout is
blocked. You may need to pull the refrigerator away
from the wall to check the pan and spout.
The light is not
working
•The LED light may be damaged. Refer to replace
LED lights in cleaning and care chapter.
•The control system has disabled the lights due to
the door being kept open for too long. Close and
reopen the door to reactivate the lights.
