Door Reversibility
Before reversing the door, please be prepared below tools and material: straight screwdriver, cross
screwdriver, spanner and the components included in the poly bag:
Left hinger x1
Left hinge cover x1
Left middle stopper x2
Left middle stopper
metal block x2
1. Close upper door, take out the screw from the top hinge covers by cross screwdriver. Take off
hinge cover, disconnect the terminal, then unscrew top hinge and take off upper door.
2. Please unwrap and take off plastic cover and wire sleeve by straight screwdriver. Please be careful
of the wire inside. Then move wire with connector to another side and install wire sleeve to another
side and fix cover back.
3. Unscrew from the middle hinge by cross screwdriver, then take off the lower door.
4. Laying down the refrigerator, take out the adjusting feet as below, then unscrew the lower hinge
by cross screwdriver.
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
