FDU-160i
FDU-160i Frequency Distribution Unit – Operation and Maintenance Manual
P/N 900000136 REV B
7
3
Setting up the FDU-160i
Power on the system by flipping switches SW1 and SW2 on the rear of the unit to the on
position. The system will display its power-on cycle on the front panel. The system will
use LED lamps D7 through D17 to indicate each octet of the device’s IP Address, Network
Mask, and Gateway address.
Write these values down and keep them in a safe place.
To display the IP address again, the front panel can be reset by pressing the RESET switch
(SW2) on the front panel.
Figure 2 - FDU-160i Showing IP Address