5
3.2.2 When in use
ALWAYS
attend to the jack would stay vertically when jacking up.
ALWAYS
make sure that the foot of the comb bar rests on the ground with the
entire contact surface.
ALWAYS
make sure the load is fitly put on the jack.
ALWAYS
pay increased attention, if the jack is drawn up to maximum position.
ALWAYS
work with the jack only with manpower.
ALWAYS
when jacking up loads with a weight oncoming safe working load of the
hoist we recommend the operation would be ensured by two persons
owing to magnitude of actuating forces.
NEVER
use the jack for anchoring of loads.
NEVER
allow the load would give rise to impacts or vibrations.
3.2.3 After use
ALWAYS
ensure the jack against incompetent use.
3.2.4 Risk analysis
The possible risks analysis in light of design, operation and environment of the jack
appointment is presented in freestanding document „Risk analysis“. It is possible to
require the document in service centers.
3.2.5 Maintenance
ALWAYS
make possible to competent persons to carry out the regular inspection
of the jack.
ALWAYS
ensure slipping parts would be sufficiently greased.
At maintenance only such interventions can be done that will be in accordance with
producer’s requirements stated in the chapter 11 and 14 of this OM.
IT IS NOT PERMITTED
to carry out repairs and maintenance in other manner than
specified by the producer. It concerns namely the forbiddance of using of unoriginal
spare parts or carrying out changes on the product without the approval of the
producer.
4 PACKING, STORAGE AND HANDLING
4.1
PACKING
4.1.1 Jacks are supplied in assembled state in bulk in transport cases.
4.1.2 The following accompanying documentation is a part of the delivery:
a) Operation Manual
b) EC Declaration of Conformity
c) Quality and Completeness Certificates and Guarantee Certificate.
c1) Guarantee period is stated in the Guarantee Certificate.
c2) The guarantee does not apply to defects caused by infringement of the
instructions stated in the Operation Manual and defects arisen by
improper using and unskilled action.
c3) The guarantee does not apply as well to changes on the product or
using of unoriginal spare parts without the approval of the producer.
