SLPt Cell Disruptor
Chapter 5: Technical Specifications
User Manual
Technical Specifications
100-214-252 Rev. A
5-1
Chapter 5: Technical Specifications
- - - - - - - - - - - - - - - - - - - 5-1
- - - - - - - - - - - - - - - - - - - - - 5-2
- - - - - - - - - - - - - - - 5-3
5.1 Technical Specifications
The following table outlines the technical specifications for the Digital Sonifier:
* Amplitude control at maximum setting. (System settings are covered in Chapter 6.)
Controls and Dislpay,
Front Panel
4 digit numeric display with provisions to set mode (Continuous,
Time, , Time Pulse, ), operating parameters (Amplitude,Time
On, Time Pulse,), and perform an executable (Reset, Test,
Enter, Start/Stop) on front panel membrane. On/Off rocker
switch to turnn on power to the unit.
Duty Cycle
Intermittent – pulse duration adjustable
[0.1 seconds – 99hrs 59 mins.] or continuous processing time
Horn Frequency
40 kHz
Line Voltage
93 to 132 VAC@ 50/60 Hz (North American and Japan)
182 to 264 VAC @ 50/60 Hz (CE and non CE units available)
Max Output Power
150 Watts
Temperature
(ambient)
Operating: 41°F (5°C) to 104°F (40°C).
Storage and shipping: -20°F (-29°C) to 158°F (70°C)
Tuning
Factory set, no tuning necessary. No user-accessible adjust-
ments.
AC Mains Fuse
8A. 250 V fast acting, 5 x 20 mm
Voltage/Current @ 150W
100-120VAC, 50/60 Hz, 2A; 200-240VAC, 1A
DOC EXPIRES 12PM 9/16/2007. Article or Material must comply with the requirements
stipulated by RoHS in its current version of 1/27/03
