Chapter 6: Operation
Operational Sequence
6-8
100-214-252 Rev. A
6.4.2 SLPt in Time Mode (Either Low, min/sec or High, hr/min)
1. Turn On power, wait for display (1) to show Ready (rdY).
2. Select Mode (2) > Time (2B). The On (3A), Off (3C), and Amplitude LED’s (3D) will light.
3. Set the On time, Off time and Amplitude % using the arrow keys.
4. Press ENTER.
5. Send Start pulse by shorting pins 2 and 6 of external user I/O, J2 to start cycle, or by pressing the Start/
Stop key, as per configuration.
6.4.3 SLPt in Time Mode with Pulse (Either Low, min/sec or High, hr/
min)
1. Turn On power, wait for display (1) to show
Ready (rdY).
2. Select Mode (2) and press until Pulse (2E) and
Time (2B) are both selected. The On (3A), Off (3C),
Amplitude (3D), and Experiment Time (3E) LED’s
will light.
3. Set the Time On, Off time, Amplitude %, and Exp
time using the arrow keys.
4. Press ENTER.
5. Send Start pulse by shorting pins 2 and 6 of exter-
nal user I/O, J2 to start cycle, or by pressing the Start/
Stop key, as per configuration.
WARNING
!
Do NOT touch the vibrating horn, or place the vibrating horn against solid objects. Touching
or holding the horn can result in burns or injury, and contacting solid materials with the vibrat-
ing horn or tip can cause breakage.
Enter
Reset
Test
Start/Stop
Mode
88:88
Continuous
Time(hr/min)
Time(min/sec)
Pulse
On
Off(sec)
Amplitude(%)
ExpTime(hr/min)
Set
4
5
6
7
3
1
2
8
9
2B
2E
2A
3C
3E
3A
3D
2C
Autotune
DO NOT REMOVE
DOC EXPIRES 12PM 9/16/2007. Article or Material must comply with the requirements
stipulated by RoHS in its current version of 1/27/03
