SLPt Cell Disruptor
Chapter 1: Safety and Support
User Manual
General Precautions
100-214-252 Rev. A
1-3
1.2.3 Safe Operation
Setup and Operation instructions are found in Chapter 6 of this manual.
For safe operation, please ensure that all people using this equipment follow those instructions and observe
all CAUTION and WARNING notices.
1.
Make sure that the equipment is properly grounded. DO NOT operate if it is not.
2.
Do not allow the horn or microtip to contact lab stands, beakers, etc. or horn/microtip failure may
result.
3.
Periodically test the equipment as described in
and
.
Although the SLPt Cell Disruptor operates outside the normal range of human hearing, some applications
can create audible noise above 85dB. If an uncomfortable level of noise is present, the operator should wear
ear protection for safe operation.
Appropriate eye protection should be worn when operating the SLPt Cell Disruptor, to prevent possible
splash injury originating in the solution.
WARNING
!
Never touch the horn or tip when ultrasonics are active. Touching the horn or tip while the unit
is on can result in serious injury. When you handle, remove, or attach a horn or tip, always
make sure that the ON/OFF switch is OFF.
1.2.4 Setting Up the Workplace
The unit should be positioned away from radiators and heating vents. A fan inside the unit maintains a safe
operating temperature in the power supply by circulating air over the components. Therefore, place the unit
so that the air intake on the bottom of the power supply is not blocked. Periodically, unplug the unit and
clean the air intake underneath the power supply to ensure that dust or dirt is not restricting the flow of air.
If the SLPt Cell Disruptor is to be used for remote operation, ensure that the unit is situated within full view
of the operator, to prevent injury or equipment damage through an accidental or automatic start-up.
DOC EXPIRES 12PM 9/16/2007. Article or Material must comply with the requirements
stipulated by RoHS in its current version of 1/27/03
