www.branxfitness.co.uk/productsupport
www.branxfitness.co.uk/productsupport
STEP 5.
PLEASE NOTE!
BEFORE PLACING THE CONSOLE AREA FLAT AND IN TO ITS
CORRCT POSITION PLEASE TAKE EXTRA CARE NOT TO CUT/DAMAGE THE CABLE
WHICH RUNS RIGHT UP THROUGH THE RIGHT TREADMILL ARM (AS IF YOU WERE
STANDING USING THE TREADMILL) INTO THE CONSOLE)
STEP 6.
FOLD DOWN THE CONSOLE IN ORDER TO SECURE IT INTO THE ARMS OF THE
TREADMILL. PLACE 1xM820 SCREW WITH WASHER INTO PLACE AND TIGHTEN
INTO PLACE IN ORDER TO SECURE THE CONSOLE SECURELY INTO POSITION.
(THE ABOVE IS REQUIRED FOR BOTH SIDES OF THE TREADMILL)
(PLEASE TAKE EXTRA CARE NOT TO DAMAGE THE CABLE AS PER STEP 5 AND
AS SHOWN HERE)
STEP 1.
YOUR TREADMILL ARRIVES FLAT PACKED AND 95% PRE ASSEMBLED.
STEP 2.
FOLD UP THE CONSOLE CAREFULLY INTO PLACE UNTIL BOTH ARMS OF THE
TREADMILL REACH THERE ASSEMBLY POINTS.
STEP 3.
PLACE 2 X M8x20 SCREW WITH WASHER TO HOLD TREADMILL ARM SAFELY IN
PLACE.
(THE ABOVE IS REQUIRED FOR BOTH SIDES OF THE TREADMILL)
STEP 4.
PLACE 1 X M8x40 SCREW WITH WASHER TO HOLD TREADMILL ARM SAFELY IN
PLACE. TO FULLY TIGHTEN THE SCREW YOU WILL NEED TO USE THE ALLEN KEY
AND SPANNER AS SHOWN.
(THE ABOVE IS REQUIRED FOR BOTH SIDES OF THE TREADMILL)
Page 10
Page 11
