15
« »
shaver is clean
« »
short economical cleaning required
«
»
normal level of cleaning required
«
» high intensive cleaning required
If the station selects one of the required cleaning
programs, it will not start unless you press the
start button
4
.
For best shaving results, we
recommend cleaning after each shave.
Whilst cleaning is in progress, the respective
cleaning program indicator will blink. Each
cleaning program consists of several cycles,
where cleaning fl uid is fl ushed through the
shaver head and a heat drying process dries
the shaver. Depending on the program selected
the total cleaning time will range from 32 to 43
minutes.
The cleaning programs should not be inter-
rupted. Please note that whilst the shaver is
drying, the shaving head may be hot and wet.
When the program is fi nished, the blue « »
indicator will light up. Your shaver is now clean
and ready for use.
Fast cleaning
Push the fast clean button
D
to activate
the fast clean program without drying. This
program takes about 25 seconds only and is
recommended when you do not have time to
wait for one of the automatic cleaning programs.
If you remove the shaver just after the program
has fi nished, wipe off the shaver head with a
tissue to avoid dripping.
Stand-by mode
10 minutes after completing the charging or
cleaning session, the Clean&Renew station
switches to the stand-by mode: The indicators
of the Clean&Renew station turn off.
Shaver display
The shaver display
z
shows the charge status of
the battery on the left, and the hygiene status on
the right. (6 dark segments are shown on each
side when the battery is fully charged and the
shaver is hygienically clean).
hy
g
ie
n
e
b
a
tt
e
ry
99973404_795cc_S4-50.indd 15
99973404_795cc_S4-50.indd 15
06.07.11 15:01
06.07.11 15:01
