Page 27
Installation Instructions
18
Mount Plastic Seat Guards to Seat
R
eposition the plastic seat guards.
Threaded insert type fasteners secure the
guards at the front corner of the seat,
(position these first and work toward the
back of the seat). There are two snap (clip)
type fasteners securing the guard along the
side of the seat, secure them.
N
ote:
Only the manual slide seat guards
should be used with the Companion Seat.
A
t this point the seat guard rear mounting
holes should align with the mounting holes
on the seat bottom. Use a T30 Torx wench
to install the OEM screws. As shown in
Photo 18b.
Torx Seat Guard Mounting Screws
Threaded Insert Fastener
Snap (clip) type fasteners
18a
18b
19
Prepare Seat for Installation
T
he manual slides have mounting studs at
each end. Using the slide adjustment lever
on each slide assembly or the slide adjust-
ment bar, adjust the stud position to be
straight across from the studs on the
opposite slide assembly. Also adjust the
stud position “front-to-back” to determine
the location of your seat after mounting it to
the Companion Seat base. If equipped
with a slide adjustment bar, remove it
before mounting (squeeze the legs of the
bar together to remove).
N
ote:
After mounting the seat, the “front-
to-back” position (slide) of the seat will not
be adjustable.
19a
Mounting Stud (4)
Manual Slide
Assembly (2)
Plastic Guards
