13
The Smoothie2Go attachment is perfectly suited
for preparing drinks and smoothies. For detailed
processing instructions refer to table II.
(C) Chopper Attachment
The chopper attachment is perfectly suited for
Chopping vegetables, hard cheese, onions, herbs,
meat and nuts. For detailed processing instructions
refer to table III.
The chopper attachment can also be used to make
a pancake stuffi
ng or spread. Fill the chopper with
30 g pitted prunes and pulse for 2 seconds.
(D) Grinder Attachment
The grinder attachment is perfectly suited for
grinding dry ingredients. For detailed processing
instructions refer to table IV.
Pulse Mode / Ice Crush
The pulse mode can be used to break apart larger
pieces of food, to crush ice or to control the texture
of food when chopping. Duration depends on how
long you hold the switch in pulse
position.
For Best Results
•
When mixing solid ingredients, cut them up into
small pieces.
•
If blending action is not suffi
cient during blending
there may be not enough liquid to blend effi
ciently.
•
For preparing small amounts of foodstuff use a
low speed level.
•
When preparing mayonnaise, oil can be added
through the openings between the measuring
cap and the lid.
•
For soft or pasty foodstuff start on speed I for the
fi rst seconds then change to speed II for further
processing.
(E) Care and Cleaning
For detailed information refer to section E.
Warranty and Service
For detailed information see separate warranty and
service leafl et or visit www.braunhousehold.com.
Troubleshooting guide
Problem
Potential Cause
Solution
Blender does not
operate
Jug is not attached properly
Check the position of the jug and the
lid. Place the jug with the handle on
the right or left side on the motor body.
Then rotate it until it is fully locked.
Motor overheating protection is
activated
Turn the blender off , unplug and wait
at least 30 minutes before continuing
blending
Jug is leaking
Gasket is not inserted or not inserted
correctly.
Check if gasket is mounted properly
and in the right order
Blade assembly is not tightly screwed
to the jug
Screw the blade assembly correctly to
the jug
Liquid splashing out
of the jug
Jug is overfi lled
Check maximum quantity
recommendation
Speed selected is too high
Check speed recommendation
5722310505_UI_JB_1xxx_INT.indd 13
5722310505_UI_JB_1xxx_INT.indd 13
13.01.22 14:14
13.01.22 14:14
