Page 18
Pre-Lift Operation Notes and Details
Lift Features
(continued)
Roll Stop Latch:
A spring-
loaded latch engages the
outboard roll stop when the
roll stop rotates upward from
ramp position to the vertical
position (UP switch is acti-
vated to raise the platform
above ground level).
Note:
The platform must
raise approximately two
inches
before
the latch
engages
fully
(see photo C on
17). L955
U
: The roll stop latch
and roll stop cylinder are on the
opposite (left) side of platform.
The latch disengages the roll
stop when the platform lowers
fully (reaches ground level)
and the latch foot contacts the
ground (latch raises above the
roll stop).
Outboard Roll Stop and Roll
Stop Latch Operation:
The lift
WARNING
Discontinue lift use
immediately if any lift
component does not
operate properly.
Failure to do so may
result in serious
bodily injury and/or
property damage.
The lift operator or attendant must
be certain
the
entire platform
reaches and rests safely on the
ground.
driven roll stop is powered by
the roll stop cylinder to auto-
matically fold (rotate) to the
vertical position when the UP
switch is activated.
