Page 9
Inspect lift for wear, damage or any abnormal
condition
Inspect lift for rattles
Correct as needed.
Correct as needed.
Outer barrier latch pivot (2)
Upper/lower fold arm telescoping area (2)
Platform pivot pin (2)
Platform fold axles (2)
Inner roll stop (
IB
) lever (2)
Inner roll stop (
IB
) lever slot (2)
Rotating pivot slide arm pivot pins (2)
Parallel arm pivot pins (8)
Handrail pivot pins (2)
Hydraulic cylinder bushings (8)
Inspect Lift-Tite
™
latch rollers for wear or damage,
positive securement and proper operation (2)
Inspect outboard barrier slide link for positive
securement and detached or missing extension
spring
Inspect outboard barrier raised and ground
detect magnetic sensors and magnet for positive
securement
Inspect IB inner roll stop (
IB
) rasied magnetic
sensor and magnet for damage and positive
securement
Inspect rotory incoder and associated components
for wear or damge and positive securement
Inspect inner roll stop (
IB
) for:
• Wear or damage
• Proper operation. Rollstop should just rest on top
surface of the base plate.
• Positive securement (both ends)
Inspect handrail components for wear or damage,
and for proper operation
Inspect microswitches for securement and proper
adjustment.
Make sure lift operates smoothly
Apply Light Oil - See Lubrication Diagram
Apply Light Grease - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil
Correct, replace defective parts and/or relubricate.
Resecure, replace or correct as needed. See Lift
Exploded View.
Resecure, replace or correct as needed. See
Switch and Sensor Location Illustration.
Resecure, replace or correct as needed. See
Switch and Sensor Location Illustration.
Resecure, replace or correct as needed. See
Switch and Sensor Location Illustration.
Resecure, replace or correct as needed. See
Platform Angle Instructions and Microswitch Ad-
justment Instructions.
Replace defective parts.
Resecure, replace or adjust as needed. See
Microswitch Adjustment Instructions.
Realign towers and vertical arms. Lubricate or
correct as needed.
Perform all procedures listed in previous section also
750
Cycles
1500
Cycles
Maintenance and Lubrication Schedule
