Page 23
Lift Operating Instructions
Lift Power
On/Off Switch
Power
Indicator
Light
Before lift operation, park the vehicle on a level
surface, away from traffic. Place the vehicle
transmission in “Park” and engage the parking
brake. Vehicle engine must be running.
Lift Operating Instructions address operation of
the lift only.
Vehicle Doors and Vehicle Interlocks: Transit
vehicle lift doors and interlocks vary. Procedures
to operate them vary also. Lift operators
(attendants) must become familiar with the vehicle
lift access door system and vehicle interlock(s).
Manual Door(s): Open manual doors fully and
secure in full open position before operating the
lift.
Do not operate the lift if you suspect lift damage,
wear, or any abnormal condition. Refer to the
Manual Operating Instructions to manually operate
lift.
Hand-held
Pendant Control
36514
Lift Power ON/OFF Switch:
This switch must be
in the ON position in order to activate the lift. The
green Power Indicator Light illuminates to signal
power to the lift.
UP:
From ground level, the UP function will
raise (rotate) the roll stop to the vertical
position. The platform then raises to floor level
position.
DOWN: From floor level,
the DOWN function
lowers the platform to ground level and then
unfolds (lowers) the roll stop to the ramp (horizon-
tal) position.
Control Switch Functions:
Hand-held Pendant Control:
The hand-held
attendant’s pendant control is equipped with two
rocker switches. When there is power to the lift,
the lift function labels illuminate to identify the
functions.
FOLD: From floor level, the FOLD function
folds the platform inward to the stowed
position.
UNFOLD:
From stowed position, the
UNFOLD function unfolds the platform out-
ward to the floor position.
Note: If any functions do not occur as
described, discontinue lift use immediately.
