USER MANUAL
10
4. Install Solder wire
a.
Pull the solder wire axis
⑧
across the framework of solder wire and
place it to the solder wire holder
⑨
back of unit. Make the notch on
each side of solder wire axis lock into solder wire holder.
b.
Pull the solder wire head and insert it into wire guide tube behind the
top, push Handspike
⑤
to widen the gap between two running gear
wheels, so it can cross the feeder tube easily.
c.
Set the Mode Switch as 0, insert power plug and turn on Power
Switch. Make the feeder tube as straight as possibly, step on Pedal
Switch or press down the red Touch Switch until the solder wire is
sent out. Turn off power switch.
5. Install Soldering Iron
Screw off Nut
②
on the bracket assembly and remove Handle clamping
element
③
. Place soldering iron in the other Handle clamping element and
install the previous one (Make the Handle in the middle of them), and then
screw on Nut
②
.
Connect plug of soldering iron handle to pin 6 receptacle in front of unit
and tighten it.
6. Adjust the position of Guide tube and Soldering tip
Turn the Connector to change combination location of Guide tube and
Soldering tip. Unscrew Locking Screw
⑭
of Guide tube and turn around
Guide tube
⑬
can also change combination location of Guide tube and
soldering tip.
Summary of Contents for QU376D
Page 18: ...BEDIENUNGSANLEITUNG 15...
