USER MANUAL
21
1. If the display windows shows
, press and hold the
“
▲
”or“
▼
”buttons simultaneously, then the display shows . This
indicates the unit comes into working mode setting state, and
pressing “
▲
” or “
▼
” button will change displayed value as shown
below:
0 1 2 3 4 5 6 7
0. 1. 2. 3. 4. 5. 6. 7.
2. After selecting the working mode, press “*” down. The working mode
is stored into the internal memory. Please refer to the “Working Mode
Table” for the meaning of the digit displayed.
Note: “X” represents original working mode digit.
WARNING: The heater and Soldering tips will be seriously
oxidized or damaged when working with a high
temperature. So please choose the working mode
carefully and try to operate with a lower temperature if
possible.
1.13.
Standby
If sleeping and working mode are selected, and the unit is not used for
20 minutes, the power to the heating element will be decreased, and
the display shows
. This state is sleeping mode. When the unit is in
sleeping mode, the tip temperature will decrease to 200
℃
(If the set
temperature is more than or equal to 200
℃
) or 50
℃
(If the set
temperature is less than 200
℃
) and remain the temperature until
resuming the unit. To resume soldering, there are several ways as
follows:
X
Summary of Contents for QU376D
Page 18: ...BEDIENUNGSANLEITUNG 15...
