USER MANUAL
9
2.5.
Parameter Settings
NOTE: The initial password is “000”. Only when the inputting
password is right or the password is 000, it can enter into the
parameter setting. If want to limit the temperature change, it
needs to change the password. The parameter setting is
including sleeping time setting, work mode setting and password
setting.
2.5.1 Inputting Right Password
2.5.1.1 Into the Parameter Setting
Press the “
▲
” & “
▼
” buttons simultaneously after the unit is
turned off. Then turn it on.
Loosen the “
▲
” & “
▼
” buttons when the window displays C, this
is the parameter setting state.
2.5.1.2 Input the Password
NOTE: There are twice chances to input password if the
password of first time inputting is wrong. If the inputting
password is wrong for the two times, it cannot come into the
parameter setting, namely it cannot set the work mode and new
password.
1.
After into the parameter setting mode, the screen displays “---” and
the 100’s cursor is flicker, which means it needs to input the
password.
2.
Input password: Click the “
▲
”or“
”button to input 100’s digit, and
then click the “*” button. After that it comes into 10’s digit input. The
inputting methods of the 10’s digit and 1’s digit are same with the
100’s digit. After selecting the 1’s digit, click “*” button.
