USER MANUAL
17
tip from being oxidized.
(3)
Use fine point tips only when necessary. The plating on fine
precision tips is less durable than the plating on blunter tips.
(4)
Do not use the tip as a prying tool. Bending the tip will cause
the plating to crack, shortening tip life.
(6) Extend tip life by switch the system off when not in use.
(7) Don’t apply pressure to the tip. More pressure does not equal
more heat. To improve heat transfer, use solder to form a
thermal bridge between the tip and the solder joint.
2.8.
Error Messages
Various error messages will be displayed when there is something
wrong with the unit.
Sensor error: If there is a failure in the sensor or
anywhere in the sensor circuit, “S-E” will be
displayed and power to the soldering iron will be
cut off.
Heater error: If power cannot be sent to the
soldering iron, the display window will show “H-E”.
This indicates the possibility of a heater
malfunction.
S - E
H - E
