Brave VH9934, Owner/Operator And Safety Manual

7.  Bolt the rail latch plate to the base unit

using a 3/8-16 x 1-1/2 inch long hex head
bolts, flat washer, and locknut as shown.

Do not overtighten the locknut.  The rail
latch should rotate freely. 

8.  Carefully lower the rail assembly to a hori-

zontal position.

NOTE: Block the wheels to prevent the base
unit from moving.

9.  Insert the clevis pin through the rail rest

and secure it with a hair pin clip on the
opposite side.

10.  Attach the hitch coupler to the end of the

tongue and front leg assembly (rear hole)
using a 1/2-13 x 3 inch long bolt, two flat
washers, and a 1/2-13 locknut.  Tighten
the locknut securely.

815-672-8861

13

Brave Products, Inc.

Troubleshooting

The following section will detail procedures for checking your log splitter, should you
encounter a malfunction.  Brave Products, Inc. recommends that you do not attempt to
make repairs to the log splitter.  In the long run, it is better to take your log splitter to a
servicing lawn and garden dealer for repairs.  

Problem: When the control handle is pushed forward (extend), the wedge does not
move.

1. Check the hydraulic tank to make sure the oil level is one inch from the top of the tank.

2. Remove the pump from the engine flange.  Check the coupler, making sure the drive

keys are in place and there is no damage to the blue urethane spider.

3. Disconnect the wedge from the cylinder.  Grasp the hydraulic cylinder shaft and try to

pull it out.  If the rod comes out easily, you will need to rebuild or replace the cylinder.

4. Once you have determined that the engine to pump coupler is intact and the cylinder

is in good condition you will need to replace the pump.

Problem:  The engine stalls when the wedge engages the wood.

1. The engine may not be properly adjusted.  Take the engine to a service center for

repair and/or adjustment.

2. If all engine settings are correct, replace the pump.

Problem: The wedge moves slowly, but will split wood.

1. Replace the hydraulic system oil filter.

2. Check the oil filter housing for dirt and debris that may have obstructed the openings.

3. If the ram speed is still slow, replace the pump.

Problem: The ram will not automatically retract.

1. Check the slide rail or wedge assembly for damage.  

2. Push the valve handle to the retract position.  If the handle will not stay in this posi-

tion, replace the valve assembly.

Brave Products, Inc.

32

815-672-8861