Brave VH9934, Owner/Operator And Safety Manual

15.  Attach the high-pressure hose from the

filter assembly to the top valve fitting.
Securely tighten the hose fitting.

NOTE: The high-pressure hose is self-seal-
ing and does not require any type of sealing
material.  Tighten the fitting with the 10 inch
crescent wrench.

16.  Attach the other high-pressure hose from

the bottom valve fitting to the pump.
Securely tighten the hose fitting.

NOTE: The high-pressure hose is self-seal-
ing and does not require any type of sealing
material.  Tighten the fitting with the 10 inch
crescent wrench.

17.  Bolt the fenders onto the fender brackets

using two 5/16-18 x 1 inch long hex head
bolts and 5/16-18 locknuts.  The fenders
are interchangeable (left or right).  Posi-
tion the fender over the tire with equal
spacing in the front and back.

815-672-8861

15

Brave Products, Inc.

c.  Remove the hydraulic tank fill cap and

fill the tank with the recommended
type and quantity of oil.  Replace the
cap.

d.  Hold the valve handle in the extend

position and pull the engine pull start
cord until the rod is fully extended.
This step pumps oil into the cylinder.

e.  Replace the spark plug and spark plug

wire.

f. Start the engine and cycle the cylinder 

several times.

g.  Retract the cylinder and shut off the 

engine.

h.  Recheck the hydraulic tank to make 

sure oil is filled within one inch from 
the top of the tank.

Brave Products, Inc.

30

815-672-8861