GB
version
E
Copyright Bravilor Bonamat B.V.
14
1.0
Fig. 10 Initial situation programming
D
Press the selection button ‘regular coffee’.
Fig. 11 Setting the amount of drink
D
With the setting key (5.6 or 5.8) set the amount
of drink
per cup
.
TIP
– By pressing the setting key (5.6 or 5.8) longer
you quickly to through the range.
– See table 1 for the factory settings and the
(im)possibilities.
– Write your own settings with a pencil in the
table.
D
Press the [Enter] key (5.7) for setting the
values for a
mug
.
D
Press the [Enter] key (5.7) for setting the
values for
half a jug.
D
Press the [Enter] key (5.7) for setting the
values for a
whole jug.
Now the amounts for ‘mild coffee’ and ‘strong
coffee’ have been set as well.
In the same way you can also determine the
amounts for ‘extra strong coffee’ and ‘hot water’.
D
Press the programming button (19.4) to finish
the programming.
Drink
Factory setting ml
Set by you
ml
‘regular coffee’ /
cup
125
g
/
‘mild coffee ‘/
‘
ff ’
mug
160
‘strong coffee’
1
/
2
jug
500
g
jug
1000
‘extra strong coffee’
cup
80
g
mug
OFF
1
/
2
jug
OFF
jug
OFF
‘hot water’
cup
140
mug
160
1
/
2
jug
500
jug
1000
Table 1 Settings of the amount of drink
6.2.2
Switching on or off the
tapping possibilities ‘mug,
half a jug or whole jug’
If the machine has been set to paid delivery,
tapping a mug, half a jug or a whole jug is
not
possible.
6.2.2.1
Switching off
D
Decrease the value set for ‘mug’ to the
minimum (§6.2.1). The display shows ‘OFF’.
Now the tapping possibilities for a mug is
switched off. When in use selecting ‘mug’ for
the drink involved gives
no
dot on the display;
this choice is not possible then.
This tapping possibility can be switched off in the
same way for all drinks.
D
Press the programming key (19.4) to finish the
programming.
6.2.2.2
Switching on
D
Increase the set value for ‘mug’ (§6.2.1). The
display again shows the value that you are to
set in ml. Now the tapping possibility for a mug
is switched on.
This tapping possibility can be switched on in the
same way for all drinks.
D
Press the programming key (19.4) to finish the
programming.
