5
EN
1.3 Eco-convenience
The
Eco-convenience
function is an automatic Eco mode in which the user pre-sets on which days and times the device
should enter Eco mode.
By programming the Eco mode, in the programming of the device, it is possible to set when the device should enter and
leave the Eco mode on desired days and times.
Per day, 3 different times should be entered.
1. Eco-out time:
Here the time is entered at which the device leaves the Eco mode.
This is the time that the device will switch off the Eco mode and starts heating again.
2. Eco-on time:
Here the time is entered at which the device enters the Eco mode.
This is the time that the device will switch to Eco mode and will no longer heat.
3. Pre-Eco time:
Here the time is entered at which the device enters
pre-Eco
mode.
This is at least 1 hour before the
Eco-on
time and at least 1 hour after the
Eco-out
time.
The moment the
pre-Eco
is switched on at the specified time, the device will not top up any more water, but the water
will be kept at the set temperature.
If the water falls below a certain level, the device will top up.
It is still possible to tap hot water.
As long as the device is in
pre-Eco
, it will keep the water at the right temperature until the
Eco-on
time is reached.
Because the device does not top up anymore during the
pre-Eco
, and therefore needs to heat less because no cold
water is added anymore, this results in a lower power consumption of the device.
1.4 Eco-smart
The
Eco-smart
function works in the same way as the
Eco-convenience
function.
Here too, three times are set, but the device will now keep track of the period of time that the device is used
in the
pre-Eco
time.
If less than 500 ml is tapped during the
pre-Eco
, the
pre-Eco
will switch on earlier next time.
However, if more than 500 ml is tapped during the
pre-Eco
, the
pre-Eco
will switch on later next time.
Example:
The
pre-Eco
time is set at 3 p.m. and the Eco on time is set at 5 p.m. every day.
On Monday the device will enter into
pre-Eco
at 3 p.m. The device will no longer top up, but it will keep the water at the
set temperature.
If the device is used rarely (less than 500 ml) between 3 p.m. and 5 p.m. (the pre-Eco time), the device will enter the
pre-Eco
fifteen minutes earlier (2:45 p.m.) on Monday the week after.
This automatic change of the
pre-Eco
time is also visible in the programming.
