![background image](http://html1.mh-extra.com/html/bravilor-bonamat/rlx-131/rlx-131_operating-instructions-manual_2805670009.webp)
GB
E
Copyright Bravilor Bonamat B.V.
V
Installation
D
The maximum acceptable ambient temperature with which a good operation can be guaranteed is 40
°
C.
D
Never install the machine in an environment where the temperature can drop below 0
°
C.
D
Do not turn over the machine, move it upright.
D
Never install the machine in places where water is sprayed or sprinkled.
D
Never install the machine in front of entrances, exits or passageways intended for emergency
services.
D
Place the machine on a sufficiently solid, flat surface close to a water connection, water discharge
and an earthed electrical power outlet.
D
Connect the machine to the electrical supply in such a way that the power can easily be
disconnected.
D
Machines hard wired into mains electricity supply we advise to use an Earth Leakage Circuit
Breaker (ELCB) of the appropriate rating (max. 30 mA).
D
Leave sufficient space at the back and front of the machine for maintenance and repair purposes.
D
The machine should be connected to the electricity mains in such a way that all phases and the zero
can easily be disconnected. The minimum distance between the contacts and the disconnected
position should be at least 3 mm.
D
Connect the machine to a readily accessible, manually operated water tap, so that the water supply
can easily be turned off.
D
Always observe local rules and standards when installing this machine.
Use
D
Inspect the machine before use and check for damages.
D
Protect the machine against water and moisture. Do not wet the machine by spraying and never
submerge the machine in water.
D
Keep the operating controls free from dirt and grease.
D
Note that during use some parts of the machine become very hot.
D
Disconnect the electricity grid and the water supply when the machine will not be used for a longer
period. Clean the machine following the instructions. Discharge the water.
D
Should the internal water ways of the machine become frozen, disconnect from the mains, turn off
the water supply and disconnect and place the machine in a warm environment until the water ways
have defrosted. Inspect and test machine for water leakage.
Maintenance and repairing failures
D
Repair and maintenance activities not included in this document must always be carried out by
service mechanics.
D
If the mains lead is visibly damaged, it has to be replaced by a qualified service technician.
D
Observe the given maintenance intervals. Overdue maintenance can lead to high repair costs and
may cause guarantee claims to become invalid.
D
Do not carry out any maintenance activities concerning the machine before having it protected
against unintentional coming into operation. In such cases disconnect the electricity grid.
D
Never leave the machine during maintenance activities.
D
For cleaning the machine only use the cleansing agent and descaler recommended by the
manufacturer.
D
Always wear suitable facial protection and gloves while working with cleansing and descaling
materials. Wash your hands after using these materials.
D
Prevent damage of the machine caused by spilled descaler solution. Remove spilled solution as
quickly as possible and follow the previously mentioned safety instructions.
Bravilor Bonamat BV