The device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device not cause harmful interference, and (2) this device must accept any
interference received, including interference that many cause undesired operation.
Part F, Information to the User
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance could
void to the user’s authority to operate the equipment.
This device must be installed by a professional installer.
The antenna(s) used for this transmitter must be fixed-mounted on outdoor permanent
structures.RF exposure compliance is addressed at the time of licensing, as required by the
responsible FCC Bureau(s) including antenna co-location requirements acc to §1.1307(b)(3).
Accessory
，
Sample of Test Procedure
1
、
Test equipment set up
1). Signal generator:
Agilent IFR3413
2). Spectrum analyzer:
ROHDE&SCHWARZ FSEA
