7
EN
• Check the delivery set.
• Examine the unit for damages, in case of damage do
not plug it into the mains.
•
Make sure that specified specifications of power
supply voltage of the power adapter correspond to
the specifications of your mains. When the unit is
used in the mains with 60 Hz frequency, it does not
need any additional settings.
• The hair clipper can operate on the built-in
rechargeable battery or on the power adapter.
BATTERY CHARGING
ATTENTION!
Do not charge the battery at temperature below 0 °C
and above +40 °C.
HAIR CLIPPER STORING/CHARGING BASE (1)
•
Before using the hair clipper for the first time it is
recommended to fully charge the battery.
• Insert the power adapter cord (9) jack into the base
(1) socket, connect the power adapter (9) to the
mains socket.
• Place the hair clipper on the base (1) (Pic. 1), the
charging level digital symbols (3) and the symbol (8)
« » will light up.
• Full charging of the battery takes about 1.5 hours,
when the battery is fully charged, the digital symbols
(3) will show full charge level «99». After 3 minutes
the digital symbols (3) will go out, and the symbol (8)
« »
will start flashing
• Disconnect the power adapter (9) from the mains.
• Battery charging option 2
• Insert the power adapter (9) jack into the socket on
the hair clipper body (pic. 1a).
• Connect the power adapter (9) to the mains, the
charging digital symbols (3) and the symbol
(8) « » will light up. When the battery is fully
charged, the digital symbols (3) will show full charge
level «99».
• Unplug the power adapter (9), disconnect the power
adapter (9) jack from the hair clipper body (pic. 1a).
•
Notes:
- do not charge the battery for more than 6 hours;
- if you didn’t use the hair clipper for more than 3
months, fully charge the battery.
BLADE BLOCK (6)
• Detachable blade block (6) is consumable and is not
covered by the warranty.
•
Clean the blade block (6) off cut hair and lubricate it
after every use. It is also recommended to lubricate
the blade block (6) before using the hair clipper.
• For lubricating the blades use the oil (14), supplied
with the unit, or the oil intended for similar devices.
• Do not use vegetable oil or oil that contains solvents.
Solvents will evaporate, and the remaining thick oil
may slow down the blades motion.
Summary of Contents for BR3401
Page 2: ...СОДЕРЖАНИЕ EN 3 DE 12 RU 23 KZ 34 ...
Page 45: ...45 KZ ...
Page 46: ......
Page 48: ...brayer pro ...
