9
EN
• After learning the hair clipper better you will be able
to use the attachment combs which leave shorter
hair.
• For even haircut make sure that the attachment
comb fits closely to the head.
• Slowly run the hair clipper through the hair, moving it
in different directions, make overlapping movements
to make sure that all areas of the hair on the head
are trimmed.
• Comb the hair along the direction of the growth to
make it easier to cut them with the clipper.
• For even haircut of wavy, thin or long hair, use the
comb to direct the hair to the blade block (6).
• From time to time clean the attachment comb from
cut hair with the brush (15).
STEP ONE
• Install the attachment comb (11 or 12). Switch the
hair clipper on by pressing the button (4) « ». Hold
the hair clipper with the blades pointed upwards.
Start cutting from the hair growth edge. Slowly move
the hair clipper upwards. Cut the back of the head
area at the bottom and near the ears.
•
Notes:
- to cut hair faster, switch the turbo mode on by
pressing the button (7) « », the symbol (2) « »
will light up. To switch the turbo mode off, press
the button (7) « » again, the symbol (2) « »
will go out.
- insert the power adapter (9) jack into the socket on
the hair clipper body (pic. 1);
- connect the power adapter (9) to the mains, the
charging level digital symbols (3) and the symbol
(8) « » will light up;
- wait for 2-3 minutes, switch the hair clipper on and
continue cutting hair.
STEP TWO
•
Switch the hair clipper off, then set the attachment
comb (13), switch the hair clipper on and continue
cutting hair near top of the head.
STEP THREE
•
Switch the hair clipper off, set the attachment comb
(10 or 11) for shorter hair and cut hair on the temples.
Switch the hair clipper off, then set the attachment
comb (12 or 13), switch the hair clipper on and
continue cutting hair towards the top of the head.
STEP FOUR
• Cut the hair from the top of the head towards the
crown against the hair growth direction.
• Use the attachments (10 or 11) for short haircut
(3-6 mm). To leave slightly longer hair use the
attachments (12 or 13) (9-12 mm).
• To leave longer hair, take hair locks between your
fingers and cut it using the hair clipper. Lift the hair
locks with the comb and cut them along the comb.
• Comb the hair to reveal uneven locks.
Summary of Contents for BR3401
Page 2: ...СОДЕРЖАНИЕ EN 3 DE 12 RU 23 KZ 34 ...
Page 45: ...45 KZ ...
Page 46: ......
Page 48: ...brayer pro ...
