9
EN
Note:
to avoid water leakage from the soleplate (11)
openings, press the burst of steam button (4) with 4-5
sec. intervals.
VERTICAL STEAMING
•
Vertical steaming of fabrics or interior objects can be
performed only in the high temperature ironing mode.
Set the temperature control knob (12) to the position
«•••» or «MAX»).
•
Hold the iron vertically at the distance of 5-20 cm
from the clothes or interior objects and press the
burst of steam button (4) with 4-5 second intervals,
steam will be released from the soleplate (11)
openings intensively.
ATTENTION!
- To avoid fabric melting, do not touch it with the iron
soleplate (11) while steaming.
- Do not steam clothes on a person. Use a clothes
hanger or a coat rack.
•
After you finish ironing, switch the iron off and
unplug it, wait until the iron soleplate (11) cools down
completely, then open the water inlet lid (2), turn over
the iron and drain the remaining water.
AUTOMATIC SWITCH OFF
•
The iron has 2 automatic switch off modes.
1. If the iron is set in horizontal position and remains
still for 30 seconds, the iron’s heating element will be
switched off, and the indicator (6) will be flashing.
2. If you set the iron in vertical position on the base
(9) and leave it for 8 minutes, the heating element will
switch off and the indicator (6) will be flashing.
•
To resume ironing set the iron from horizontal
position to vertical or vice versa, wait until the iron
soleplate (11) heats up and continue ironing.
STEAM CHAMBER CLEANING
•
Regularly clean the steam chamber of the iron,
especially in the regions with «hard» tap water.
•
Set the continuous steam supply knob (5) to the
position « » (steam supply is off).
•
Open the lid (2), fill the tank with water up to the
maximal mark «МАХ» and close the lid (2).
•
Place the iron on its base (9).
•
Insert the power plug into the mains socket.
•
Set the temperature control knob (12) to the «MAX»
position, the indicator (6) will light up.
•
When the iron soleplate (11) reaches the set
temperature, the indicator (6) will go out and you can
start cleaning the steam chamber of the iron.
•
Remove the power plug from the mains socket.
•
Hold the iron above the sink horizontally, press and
hold down the button (13) «Self -Clean».
•
Boiling water and steam with scale will be intensively
released from the soleplate (11) openings.
•
Slightly sway the iron back and forth, until all the
