7
EN
USING THE CONVECTION FAN HEATER
• Place the convection fan heater vertically on an even
dry moisture- and thermal-resistant surface, do not
place it horizontally and do not turn it over.
• Do not place the convection fan heater on soft
surfaces, such as carpets with high pile, sofas or
beds.
• The distance between the convection fan heater and
the furniture should be at least 1 m.
• To avoid mains overloading, do not switch on several
electrical appliances with high power consumption at
the same time.
• Insert the power plug into the mains socket.
• Set the operation mode switch (3) into the necessary
position:
-
«0» – the unit is off;
- «
» – low power (1000 W);
- « » – maximal power (2000 W).
• • Turn the thermostat control knob (4) clockwise to
the maximum position «МАХ»; the light indicator (5)
will light up. When the desired air temperature in the
room is reached, turn the thermostat control knob
(4) counterclockwise until a distinctive click, while
the light indicator (5) goes out, in this position of the
thermostat the set air temperature in the room will be
maintained.
• To increase the air temperature in the room, turn the
thermostat knob (4) clockwise and counterclockwise
to decrease it.
Note:
- the fan heater will not switch on if the thermostat
settings correspond to the air temperature in the room.
•
After the unit operation is finished, turn the
thermostat control knob (4) counterclockwise as far
as it will go and set the operation mode switch (3) to
the position «0» and unplug the unit.
Note: -
when you switch the unit on for the first time,
some smoke or foreign odor may appear. It is normal
and not covered by warranty.
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
• If the outgoing air temperature exceeds the
acceptable value, the automated thermal switch will
switch off the convection fan heater.
• Set the operation mode switch (3) to the position
«0» and unplug the unit, let the unit cool down
for approximately 15-25 minutes (the waiting time
depends on the room temperature), and only then
you can switch it on again.
• Make sure that the upper and bottom air grids are not
blocked with foreign objects.
• Insert the power plug into the mains socket and
switch the unit on.
• If the convection fan heater does not switch on, it
may be caused by another malfunction. In this case
apply to a service center for repairing of the unit.
