1
Align the mounting holes in the modesty brackets
with the lifting column supports and the rear wall
panel. Orient the modesty brackets as shown with
tab hooks towards the inside. The lifting column
supports and modesty brackets are universal right
and left. Attach using provided washers and bolts.
1
Preparing The Lifting Columns
Lifting column is pre-installed with M6x10 bolt.
Insert lifting column into the keyway on the
framework then lock in place from the side
by attaching with M6 screw.
2
Install cantilever support with screw and
star washer to framework.
1
Adjust the framework to
the distance between the bases.
Slide the assembled lifting columns and
framework in to the base attached to
the back panel.
| Mesa Adaptive Wall Mount Electric HA Table
Installation Guide
2022 R1
Wall Mount Height Adjustable Mesa Assembly
This guide assumes that the wall mounting surface is level and plumb. Mounting into wood wall studs or concrete is recommended. For metal wall studs or otherwise,
sufficient support must be added to accommodate heavy loads. Contact your BRC representative for weight limit requirements and recommendations.
Preparing The Wall Panel
2
Connect the lifting columns
to the bottom of the base
using screws and star
washers.
x
D Nut Inserts, 5/16"-18 x 5/8"
X8
Flat Washer 1/4" ID 9/16" OD
X8
Hex Head Bolt, 5/16"-18
X8
Flat Head Screw, M6x12
X4
Flat Head Screw, M6x12
X4
Socket Head Screw, M6x16
X8
Star Washer, M6
X8
Page 1 of 3
BRC GROUP • www.brc.group • info@brc.group • 877.260.4309
Wall panel
Lifting Column
Supports
Modesty
Brackets
