This page is intentionally blank.
Subject to change without notice. Copyright @ 2013. Sunrise Medical.
User Guide – Rolling Walkers. Rev. A
Page 5 of 11
WARNING
Before use check to make sure screws are tight and product is stable.
FAILURE TO FOLLOW THE ABOVE INSTRUCTIONS MAY RESULT IN
SERIOUS INJURIES.
SAVE THESE INSTRUCTIONS
ASSEMBLY / FITTING INSTRUCTIONS
This rollator is supplied fully assembled with the exception of the handles,
backrest and basket.
To open
the rollator, hold it by the seat handle, push down and the wheels will
spread. The seat is now support on the rear crossbar.
Fit the handles
to the vertical frame tubes.
Position the first handle to the height required, line up the hole for the bolt and
the appropriate hole in the handle and insert the bolt from the inside of the
frame.
Slide the curved washer onto the bolt and fit the locking wheel, ensuring the
hexagonal bolt head is located in the cut-out of the tube to stop it from
reloading. Tighten the locking wheel and check the handle is secure. Repeat
for the other handle.
To fit the backrest
, locate the open ends of the backrest in the location tubes
at the front of the rollator above the seat.
