Breezy HeliX2, Directions For Use Manual

ENGLISH

32

HeliX

2

Options - Backrest

ADJUSTABLE BACKREST 

ANGLE

The angle of the backrest can 

be set to 6 different positions 

(-5° forwards, 0°, 5°, 10°, 15° 

and 20° backwards). To adjust 

the angle, remove the screw 

(1), set the desired angle and 

then re-tighten the screw. 

(Fig. 26). 

By releasing the clamp lever 

(1) the backrest height can be 

infinitely adjusted from 35 – 50 

cm.

FOLDING BACKREST

To flip the backrest up:

To flip the backrest up push the 

handles upwards and forwards, 

until they click into place.

WARNING!

Keep fingers and other  

objects away from the  

folding mechanism  

when you are folding the    

backrest, to avoid   

injuries or damage.

Folding the backrest down:

The backrest can be folded 

down to make it easier to 

transport the wheelchair.

CAUTION!

Do not do this when any load is 

applied, as otherwise the lever 

could break.

To fold the backrest down, push 

the two small levers 

(Fig. 27 + 28) on both sides of 

the backrest. 

RECLINING BACKREST 

ANGLE  

(7° - 30°)

By pulling both levers together 

(1), you can release the 

backrest and then move it to 

the desired position.
On releasing the two levers (1) 

the backrest will automatically 

lock into place (Fig. 29).

WARNING!

• 

The reclining backrest can only be used in conjunction with the 

wheelbase extension.

• 

It is recommended that the reclining backrest is used in 

conjunction with anti-tip tubes (maximum ground clearance 3-5 

cm).

• 

We recommend that the reclining backrest is used in conjunction 

with a stabilising bar.

Fig. 27

Fig. 28

Fig. 26

1

Fig. 29

1

ADJUSTABLE BACK 

SLING

The adjustable back-sling

can be adjusted for tension

by using several straps. 

(Fig. 30).

CAUTION!

Do not pull the tension belt too 

tight, otherwise this could 

interfere with the folding 

mechanism for the chair.

Fig. 30

Options – Comfort back

COMFORT BACK

The comfort back permits 

comfortable long seating with 

lateral support and is height, 

depth and angle adjustable.

To remove, push each release 

lever (1) forward to unlock. 

Once both levers are in the 

forward position, simply lift the 

back straight up. 

To re-attach the back, simply 

line up the pins to the receivers 

and push into place. If properly 

inserted the pins will “click” to a 

locked position.

The two locking pins which, 

when secured, prevent the 

back from being released from 

the chair. To lock, insert the 

pins into the mounting 

receivers. Simply remove the 

pins if the quick-release 

capability is desired, 

(Fig. 31-32).

TRUNK SUPPORT

The trunk support can be 

adjusted in angle, depth and 

height. It can be swing away 

by lifting it upwards, (Fig. 33). 

DEPTH ADJUSTMENT: 

Remove the 2 screws and fit 

the trunk support in the new 

position. Finally tighten screws 

again. 

ANGLE ADJUSTMENT: 

Open screw, set the trunk 

support into the desired angle and tighten the screw  again. 

HEIGHT ADJUSTMENT: 

Remove the fixing screws of the bracket and move the bracket into 

the desired position. Finally tighten the screws again.

Options – Trunk support

Fig. 31

Fig. 33

1

Fig. 32