Page 1
BREL motors is part of:
Instruction Brel electronic DC radio motor double shaft for VB/PB/Roman
Type MJE24D
Read the manual before you begin the installation. If these instructions are not followed,
this may lead to defects and injury in which warranty
can’t be claimed.
warning:
Children cannot recognize the dangers of electrical equipment and may therefore not work with it.
It is important to follow this instruction for your own safety.
1. Do not operate the motor in humid surroundings.
2. The motor must be installed correctly.
3. Keep the antenna in a good condition and do not shorten. The antenna should not come into contact with other metal parts
otherwise it will reduce the effect.
4. The motor must be protected from direct moisture influences.
5. The motor should be installed with the motor cable down in order to prevent moisture via the motor cable is running in the
motor . See Figure 1
6. It is prohibited to connect two motors on a switch without using a relay control.
Figure 1
______________________________________________________________________________
(mode en time have only a function
at a remote with a timer: DC458 en DC 920)
Up
P2
Mode
P1
Channel - stop
C
Time
Down
If you are using a multi-channel transmitter, you cannot program on the shared channel.
______________________________________________________________________________
Technical data of the motor
Type MJE24D
•
Motor Voltage :
DC 12V
•
Maximum ampère charger:
1.0 A
•
Power:
10 Watt
•
Torque:
0.8 Nm
•
Speed:
45 rpm
•
Ampèrage:
0.90 A
•
Moisture and dust:
IP40
•
Storage capacity is up to 20 channels
•
Working temperature of the motor:
o
Normal use:
-10
℃
tot +40
℃
o
Heavy use:
-20
℃
tot +70
℃
