Pagina 1
Manual Brel special bi-directional zipscreen motor
Type BZE45
Read the manual before you begin the installation. If these instructions are not followed,
this may lead to defects and injury in which warranty can’t be claimed.
warning:
Children cannot recognize the dangers of electrical equipment and may therefore not work with it.
It is important to follow this instruction for your own safety.
1.
Do not operate the motor in humid surroundings.
2.
The motor must be installed correctly.
3.
Keep the antenna in a good condition and do not shorten.
The antenna should not come into contact with other metal
parts otherwise it will reduce the effect.
4.
The motor must be protected from direct moisture influences.
5.
BREL-Motors declares that this motor has been manufactured according to the guidelines of the CE standard 1999/5/EC.
_______________________________________________________________________________
Wiring
_______________________________________________________________________________
Functions remote control
Changing batteries
DD-2702H
Works with all BREL transmitters:
Always check that the remote control is in Bi-directional mode!
Refer to manuals for remote controls at
www.brel-motors.nl
_______________________________________________________________________________
Technical data of the motor BZE45-20
BZE45-40
NOTE:
If the motor has been running continuously
for 4 minutes, it may become too hot and
then stop. After approximately one hour
half an hour, this one will continue to run.
