CHANGING THE STRAp
Your AC-R-TI is supplied with its own tool to allow the removal and assembly of its
strap of which is retained in place using a bar and two threaded inserts.
REMOVING A STRAP
1.
Ensure that the hexagon drive bit is
fully extended. This can be achieved by
holding the small end of the tool and
rotating the main body clockwise.
2.
Locate the drive bit into the threaded
insert you wish to remove. Rotate the
main body anti-clockwise to loosen and
unscrew the threaded insert until the
strap bar end is visible (there is no need
to remove the insert from the case).
Support the strap when removing to
ensure that it isn’t damaged or is dropped.
3.
Remove the threaded insert from the
tool.
4.
Repeat for the opposite threaded insert, removing the strap via the slots in the case
lugs when clear. Remove the bar from the strap if required. Repeat for the opposing side if
required.
Press Push-Button A
1 - START
Depress Push-Button A
2 - STOP
Push-button B
3 - RESET to zero
CHRONOGRApH TIMING FUNCTION
Pressure must not be applied to both pushers
simultaneously.
Summary of Contents for AC-R-TI
Page 1: ...BREMONT AC R TI TECHNICAL NOTES ...
Page 50: ......
Page 51: ...W W W B R E M O N T C O M ...
